The Difference Between Automotive Stamping Molds and Hardware Molds and Requirements for Raw Material

1. Some questions about automotive stamping parts

(1) What is the FLUSH in the inspection tool measurement when we are testing automotive stamping parts? In addition, which parts of the car need the four-step stamping process?

For the inspection of automotive stamping parts, then, there is the word FLUSH in the inspection tool measurement, and its professional interpretation is flush plane inspection. In automobile parts, there must be a four-step stamping process, which is for some large covering parts, and they are all automotive stamping parts.

(2) Is there any difference between automotive stamping dies and hardware stamping dies?

If you compare automotive stamping dies with hardware stamping dies, you will find these two are different. Because for the former, there are many technical requirements for the A side, while for the latter, there is no requirement in this regard. Therefore, the difference between the two is mainly in technical requirements.

2. Specific requirements for raw materials of automotive stamping parts

The raw materials of automotive stamping parts must have quality certification, and they must meet the relevant technical requirements, otherwise, they cannot be used. In addition, some corresponding analysis or laboratory work can be carried out to check the performance of the material and whether there are defects, so as to judge whether it is usable. And, if necessary, re-inspection of raw materials can also be carried out to ensure that there is nothing wrong.